产品详情 //

产品性能测试：

Product performance test:

测试条件：

Preparation of test panels:

1、 喷涂底材：ABS塑胶板

1. Substrate: ABS plastic plates

2、 前处理：用清洁剂擦拭面油污及尘粒

2. Surface pretreatment: Removing grease and dust, with detergent.

3、 漆膜厚度：8~12um(空气喷涂)

3. Film thickness:20~25um（air spray coating）

4、 预干燥：60℃ X 5min

4.Pre- drying: 60℃ X 5min

注意事项：

Notes:

1、 涂料应密封贮存于阴凉处，防水、防晒、防高温、远离火源。

1. Sealed and stored in the dry and cool environment. Kept away from water , sunshine, high-temperature and fire.

2、 涂料在室温下不开罐的贮存期为半年。

2. Storage period of coating is half a year in room temperature under tank sealing condition.

3、 底漆在各自工艺条件下完全干燥后方可喷涂面漆。依据不同的底漆或基材附著不好的现象可能发生，使用前请确认。

3. The primer must be cured thoroughly before application of UV coatings, otherwise the poor adhesion may occur.

4、 使用前请用400目的滤网过滤。

4. Filtered with 400# silk gauze before use.

5、 用于被要求有耐磨性的用途时，需提高面漆膜厚，否则会影响到漆膜性能。

5. If wear resistance is required in application, thickness of finishing coat film needs to be increased. Otherwise, coat film performance may be affected.