产品详情 //

产品性能测试：

Product performance test:

试验项目 TEST ITEM	试验方法 TEST CONDITION	试验结果 TEST TRSULT
附着性 Crosshatch adhesion	1mm2方格100个，3M600胶纸测试 A grid of 100 square(1mm2).peeled with a pressure 3M600 tape	5B 5B
铅笔硬度 Pencil hardness	GB6739	HB
耐磨耗性 Abrasion resistance	RCA磨耗试验 RCA Abrasion test	≥50次 ≥50time
耐湿性 Humidity resistance	40℃×90%RH,240h	良好 Good
耐热性 Heat resistance	60℃×120h	良好 Good
耐热水性 Hot water resistance	60℃热水中浸泡2h,进行附着力测试 Immersed in 60℃ water 2h,and crosshatch adhesion	良好 Good
耐手汗 Sweat resistance	D1N53 160标准 DIN53 160 standard	良好 Good
耐醇性 Alcohol resistance	乙醇（99.5%），500g/ cm2擦试，露底前的回数 99.5% alcohol ,W=9.8(lkgf) calculate rubbing times before film abrading	≥100回 ≥100time
耐侯200h， 人工加速化 Weatherability 200h artificial accelerated ageing	ASTM G53	表面无明显变化 No apparent change occurs to the surface

测试条件：
Preparation of test panels
1. 喷涂底材：ABS
1. Substrates: ABS
2. 漆膜厚度：10～15 μm
2. Film thickness: 10～15 μm
3. 烘烤：放置5-10min，60℃×30min干燥，放置72小时后试验
3. Baking condition：Placed in 5 to 10 min，60℃×20min drying stay for 72 hours before test.
4. 稀释剂：蒸馏水
4. Thinner: Distilled water
注意事项：
Notes:
1. 涂料开罐后请充分搅拌至均匀方可使用。
1. Thoroughly mixed before use.
2. 成型时的脱膜剂及其它灰尘等附着物，请在涂装前擦试干净。
2. The substrate must be free from lubricant, smut and other dirt prior to application.
3. 视底材不同附着力也有不同，涂装前充分确认漆膜性能。
3. Please confirm the ability of the paint film before application due to its different adhesion on varieties of substrates.
4. 与其他涂料重复涂装时，可能发生龟裂，请先进行充分确认。
4. Please notices that crackling may occur when it coats with other panits.
5. 涂料在室温下不开罐的贮存期为六个月。
5. Storage period of coating is six months in room temperature under tank sealing condition